PocketWizard N10-ACC-1 Compatibility:

• PlusX
• Plus III
• FlexTT5
• MultiMAX with ACC port to a Nikon 10-pin remote shutter release terminal
•For the Plus II, older MultiMAX or other PocketWizard radios, Please use a N90M3 or a N90M3-P cable.

Description: This is a special remote shutter release cable called a Pre-Trigger Cable. A Pre-Trigger cable controls both the half-press and full-press function of your remote camera’s shutter release. When a camera is “pre-triggered”, it is like holding your camera’s shutter release button in the half-pressed or metering/focusing position.
This cable contains a ""no diode"" circuit necessary only for the newer Nikon cameras, but will work with other cameras as listed below. It will not work with the Nikon D200 or D100 w/ MB-D100. Use the N10-ACC-D200 (formerly the N90M-ACC) cable for those cameras.

This N10-ACC (formally the N90M-ACC-ND) cable allows a compatible PocketWizard radio to independently control both half-press and full-press functions.

Compatible with the following radios:

PlusX: Use this cable with the PlusX to trigger the camera.

Plus III: Use this cable with the Plus III’s exclusive 2-stage trigger to wake-up or focus your remote camera just like using the camera’s shutter release button.

FlexTT5: This cable is required for auto-relay mode with E-TTL, or other remote triggering with the FlexTT5. Learn more here. You can use a N90M3–P (-P) Pre-Trigger cable or N90M3 standard cable with a FlexTT5, but your remote camera will not be able to relay an E-TTL signal to Speedlites. The FlexTT5 does not support the 2-stage trigger function.

MultiMAX with –ACC port: Enable a remote zone with your hand-held MultiMAX, and your remote MultiMAX will wake up its remote camera with this cable. As long as the zone is turned on, the remote camera will stay awake and respond more quickly and consistently, but also consume the camera's batteries much more quickly. When the remote zone is disabled, the camera will enter its normal sleep modes. The MultiMAX does not support the 2-stage trigger function.

NOTE: An older mono motor drive cable and/or pre-release cable can be used instead of an -ACC cable with a FlexTT5 but you will not have E-TTL capability.

Please see our PocketWizard Wiki for more details.

Compatible with cameras using Nikon's 10-pin remote terminal including:

Nikon
Nikon Kodak
Fuji
N90
D3
DCS Pro SLR/n S3 Pro
N90s
D3s DCS Pro 14n
S3 Pro UV IS
F5
D3X
DCS 760
S5 Pro
F6
D4
DCS 720x
IS Pro
F100
D4s DCS 660

D1
D300 DCS 660M

D1H
D300s
DCS 620

D1X
D700
DCS 620x

D2H
D800
D2Hs
D800E

D2X D810

D2Xs

Trademarks are the property of their respective owners.